LED solar road lighting installation

LED solar road lighting installation

⒈Determine the position of the standing lamp; survey the geological conditions, if the ground surface is soft and soft soil at 1 m2, then the excavation depth should be deepened; at the same time, confirm that there are no other facilities (such as cables, pipes, etc.) below the excavation position, and there is no top of the led solar street light Shade the object for a long time, otherwise the position should be changed appropriately.

⒉ Reserve (excavate) a 1.3-meter pit that meets the standard at the position of the vertical lamp; carry out the positioning and pouring of the embedded parts. The embedded part is placed in the center of the square pit, one end of the PVC threading pipe is placed in the middle of the embedded part, and the other end is placed in the storage area of the battery. Pay attention to keeping the embedded parts, the foundation and the original ground on the same level (or the top of the screw is on the same level as the original ground, depending on site needs), and one side must be parallel to the road; this will ensure that the LED solar street light pole is erected Correct and not skewed. Then use C20 concrete to pour and fix. Do not stop using the vibrator to vibrate during the pouring process to ensure the overall compactness and firmness.

⒊ After the construction is completed, clean up the residue on the positioning plate in time, and clean the impurities on the bolts with waste oil.

⒋During the concrete solidification process, water should be regularly watered for curing; the chandelier can only be installed after the concrete has completely solidified (generally more than 72 hours).

Battery assembly installation

⒈Before connecting the output positive and negative poles of the solar panel to the controller, measures must be taken to avoid short-circuiting;

⒉Solar battery module and bracket must be firmly and reliably connected;

⒊The output wire of the module should be avoided exposed and fastened with a cable tie;

⒋The orientation of the battery assembly should face due south, whichever is the direction of the compass.

Battery installation

⒈When the battery is placed in the control box, it must be handled gently to prevent damage to the control box;

⒉The connecting wires between the batteries must be bolted on the terminals of the batteries and copper gaskets should be used to enhance conductivity;

⒊ After the output line is connected to the battery, it is forbidden to short-circuit under any circumstances to avoid damage to the battery;

⒋When connecting the output wire of the battery to the controller in the telegraph pole, it must pass through a PVC threading pipe;

⒌After the above is completed, check the wiring of the controller end to prevent short circuit. Close the door of the control box when it is normal.

LED solar road lighting installation

⒈The LED solar street lamp manufacturer fixes the components of each part: the solar panel is fixed on the solar panel bracket, the led solar street lamp head is fixed to the arm, and then the bracket and the arm are fixed to the main pole, and the connecting wire is passed to the control box ( battery box).

⒉Before lifting the lamp pole, first check whether the fasteners of each part are firm, whether the lamp holder is installed correctly, and whether the light source works normally. Then check whether the system is working normally; loosen the solar panel connection line on the controller, and the light source works.

⒊When lifting the main light pole, pay attention to safety precautions; the screws must be fastened, if the component's sun-facing angle is deviated, you need to adjust its sun-facing direction to the full south.

⒋Put the battery into the battery box, and connect the connecting wire to the controller according to the technical requirements; first connect the battery, then the load, and then the solar panel; when wiring, be sure to pay attention to the wiring of each way and the terminal marked on the controller. Wrong connection, the positive and negative polarities cannot collide, and cannot be reversed; otherwise, the controller will be damaged.

⒌Check whether the system is working properly; loosen the solar panel connection line on the controller, the light is on; connect the solar panel connection line, the light is off; at the same time, carefully observe the changes of the indicators on the controller; everything is normal, then the control can be sealed box.